ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
NOTE
Install a new capacitor so that positive end of capacitor is connected under
brush.
(7)
Install capacitors as tagged and secure with screws and washers. Remove tags.
(8)
Assemble alternator assembly. Refer to paragraph 5.28.e.
(9)
Tighten nuts securing positive terminals to rear housing. Install capacitor leads. Install battery post
strap and secure with nylon locknuts.
FRAME.
a. Removal.
(1)
Remove control panel assembly. Refer to paragraph 4.20.b.
(2)
Remove fuel tank and piping. Refer to paragraph 4.17.a.
(3)
Remove engine harness assembly. Refer to paragraph 4.58.c.
(4)
Remove alternator harness assembly (MEP-501A). Refer to paragraph 4.59.c.
(5)
Remove diesel engine and alternator assembly. Refer to paragraph 5.9.a.
(6)
Remove diesel engine resilient mounts. Refer to paragraph 4.12.6.a.
b. Repair.
WARNING
CARC paint dust is a health hazard. Wear protective eyewear, mask, and
gloves when sanding CARC painted surfaces. Failure to comply can cause
personal injury.
(1)
Repair all dents and cracks. Replace damaged threaded inserts. Remove all loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surface in accordance with TM 43-0139/TO 35-1-3.
c. Installation.
(1)
Install diesel engine resilient mounts. Refer to paragraph 4.12.6.b.
(2)
Install diesel engine and alternator assembly. Refer to paragraph 5.9.b.
5-92
