ARMY TM 9-6115-673-13&P
AIR FORCE TO 35C2-3-512-1
a.
Removal.
(1) Shut down generator set.
(2) Remove capscrews (Figure 4-7), lockwashers, and washers securing resilient
mounts to engine support bracket.
(3) Remove capscrew, lockwasher, and washer securing ground strap to side of
engine crankcase.
CAUTION
Use caution not to lift engine so high that fuel line from fuel tank
to fuel filter stretches and breaks.
(4) Lift engine, with support bracket, approximately 1-1 inches and insert block under
engine to hold in position.
(5) Remove nuts, lockwashers, washers, ground strap, and capscrews with washers
securing resilient mounts to generator set frame. Then remove and discard
resilient mounts.
b.
Installation.
(1) Position new resilient mounts on generator set frame and secure with capscrews,
washers, lockwashers, and nuts ensuring engine ground strap is installed under left
rear nut and washers. Torque nuts to 17 lbs-ft (23 Nm).
