FUEL FILTER ASSEMBLY.

ARMY TM 9-6115-673-13&P

AIR FORCE TO 35C2-3-512-1

FUEL LINE

TUBING

FITTING

CLAMP

FITTING

Figure 4-12. Fuel Lines, Clamps, Fittings (Typical)

NOTE

If removing tank-to-filter fuel line tubing, fuel tank must be

drained.

(2) If necessary, open fuel tank drain cock (Figure 4-14) and drain fuel into suitable

container. Close fuel tank drain cock. Fuel tank capacity is 1.6 gal. (6.1 L).

(3) Loosen hose clamps (Figure 4-12) and remove fuel line tubing.

(4) Remove fittings as necessary.

Installation.

(1) Install fittings (Figure 4-12) as necessary.

(2) Install fuel line tubing and tighten clamps.

(3) If drained, fill fuel tank with diesel fuel (DL-1, DL-2, or JP-8).

(4) Prime and bleed the fuel system. Refer to paragraph 2.7.c.

FUEL FILTER ASSEMBLY.

NOTE

For generator sets with the original Mechron configuration fuel

filter assembly, replace entire assembly with the assembly

listed in this manual. Shorten fuel line from fuel tank to fuel

filter assembly by approximately two (2) inches to reduce slack

in fuel line.