ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-163
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove radiator, step a above.
(3)
Inspect radiator for excessive corrosion and scale.
(4)
Check inside of radiator for corrosion and scale.
__________
WARNING
Cleaning with compressed air can cause flying particles. When using
compressed air, wear protective glasses and use clean, low pressure air, less
than 30 psi (206.8 kPa). Failure to comply can cause eye injury.
(5)
Clean dirt particles from radiator core air passages using filtered, compressed air, 30 psi maximum.
(6)
Clean exterior surface of radiator with soap and water.
(7)
Install radiator, step d below.
c. Repair.
For repair, refer to paragraph 5.6.1.
d. Installation.
(1)
If removed, install radiator support (37, Figure 4-22), bolts (36), lockwashers (35), and nuts (34) on
generator set.
(2)
Install coolant drain valve (33) on radiator (32).
(3)
Position radiator (32) on radiator support (37), and install washers (31) and locknuts (30).
(4)
Install shroud (19), washers (18), lockwashers (17), and bolts (16).
(5)
Position hose clamp (28) and drain hose (29) on coolant drain valve (33). Tighten hose clamp.
(6)
Install spacers (27), support tie-rods (24), lockwashers (26), and bolts (25) on radiator (32).
(7)
Install support tie-rods (24), washers (23), bolts (22), lockwashers (21), and nuts (20) on bracket on
engine.
(8)
Install lower coolant hose, paragraph 4.10.5.
(9)
Install upper coolant hoses, paragraph 4.10.4.
(10) Install filler hose and panel, paragraph 4.10.2.
(11) Install fan guards, paragraph 4.10.3.
(12) Install top section housing, paragraph 4.7.3.
(13) Close coolant drain valve (33), and add coolant/antifreeze to proper level, paragraph 3.3.4.
