ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-96
c. Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Release DCS control panel by turning two fasteners, and lower DCS control panel slowly.
(4)
Tag and disconnect electrical leads from FREQUENCY ADJUST switch (13, Figure 4-13).
(5)
Remove jamnut (11) and toothed washer (12) securing FREQUENCY ADJUST switch (13) to DCS
control panel.
(6)
Remove FREQUENCY ADJUST switch (13) and tab washer (14) from DCS control panel.
(7)
Position tab washer (14) and FREQUENCY ADJUST switch (13) on DCS control panel.
(8)
Secure FREQUENCY ADJUST switch (13) to DCS control panel with toothed washer (12) and
jamnut (11).
(9)
Connect electrical leads to FREQUENCY ADJUST switch (13), and remove tags.
(10) Raise and secure DCS control panel with two fasteners.
(11) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.12 PANEL LIGHTS Switch S2.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Release DCS control panel by turning two fasteners, and lower DCS control panel slowly.
(3)
Inspect PANEL LIGHTS switch (18, Figure 4-13) for loose connections and mounting hardware,
and other damage.
(4)
Raise and secure DCS control panel with two fasteners.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Release DCS control panel by turning two fasteners, and lower DCS control panel slowly.
(4)
Tag and disconnect electrical leads from PANEL LIGHTS switch (18, Figure 4-13).
(5)
Set multimeter for ohms, and connect across PANEL LIGHTS switch (18) terminals 5 and 6 and 2
and 3. Refer to Schematic FO-1.
(6)
Place PANEL LIGHTS switch (18) in ON position. Multimeter should indicate continuity between
terminals 2 and 3, and 5 and 6.
