ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-97
(7)
Place PANEL LIGHTS switch (18) in OFF position. Multimeter should indicate open circuit
between terminals 2 and 3, and 5 and 6.
(8)
If indications are not as above, replace PANEL LIGHTS switch (18).
(9)
Connect electrical leads to PANEL LIGHTS switch (18), and remove tags.
(10) Raise and secure DCS control panel with two fasteners.
(11) Connect negative battery cable to battery, and close BATTERY ACCESS door.
c. Replacement.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Release DCS control panel by turning two fasteners, and lower DCS control panel slowly.
(4)
Tag and disconnect electrical leads from PANEL LIGHTS switch (18, Figure 4-13).
(5)
Remove jamnut (16) and toothed washer (17) securing PANEL LIGHTS switch (18) to DCS control
panel.
(6)
Remove PANEL LIGHTS switch (18) and tab washer (19) from DCS control panel.
(7)
Position tab washer (19) and PANEL LIGHTS switch (18) on DCS control panel.
(8)
Secure PANEL LIGHTS switch (18) to DCS control panel with toothed washer (17) and jamnut
(16).
(9)
Connect electrical leads to PANEL LIGHTS switch (18), and remove tags.
(10) Raise and secure DCS control panel with two fasteners.
(11) Connect negative battery cable to battery, and close BATTERY ACCESS door.
