ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-42
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause
personal injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Replace damaged grommets (28 and 29, Figure 5-4) and door seal (31).
(4)
Using adhesive (1, Appendix E), replace damaged protective edging (30).
(5)
Using adhesive (1, Appendix E), replace damaged EMI seal (32).
(6)
Repaint surfaces in accordance with TM 43-0139.
d. Installation.
(1)
Install grommets (28 and 29, Figure 5-4) in real panel (33).
(2)
Install side panel (27), bolts (26), and locknuts (25) on rear panel (33).
(3)
Install side panel (24), bolts (23), and locknuts (22) on rear panel (33).
(4)
Position output box panels (33, 27, and 24) in generator set, and secure with bolts (21) and
locknuts (20).
(5)
Install cranking relay (19), screws (18), and locknuts (17) on side panel (27).
(6)
Install AC circuit interrupter (16), screws (15), and locknuts (14) on rear panel (33).
(7)
Install output box wiring harness, paragraph 5.8.3.
(8)
Install current transformer, paragraph 5.8.4.
(9)
Install power potential transformer, paragraph 5.8.6.
(10) Install droop current transformer, paragraph 5.8.5.
(11) Install voltage reconnection terminal board, paragraph 5.8.2.
(12) Install output box top panel (13), bolts (12), and locknuts (11) on output box assembly.
(13) Install air cleaner assembly, paragraph 4.9.2.
(14) Install output box access door. Refer to paragraph 4.7.1.
(15) Install rear housing panel. Refer to paragraph 4.7.5.
(16) Install DCS control box assembly, paragraph 4.8.1.
