ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-41
5.8.7
Output Box Panels.
a. Inspection.
(1)
Inspect output box panels (13, 24, 27, and 33, Figure 5-4) for cracks, dents, loose paint,
corrosion, and other damage.
(2)
Inspect grommets (28 and 29), protective edging (30), door seal (31), and EMI seal (32) for
looseness, tears, deterioration, and other damage.
b. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Remove DCS control box assembly, paragraph 4.8.1.
(4)
Remove rear housing panel. Refer to paragraph 4.7.5.
(5)
Remove output box access door. Refer to paragraph 4.7.1.
(6)
Remove air cleaner assembly, paragraph 4.9.2.
(7)
Remove locknuts (11, Figure 5-4), bolts (12), and top panel (13) from output box assembly.
(8)
Remove voltage reconnection terminal board, paragraph 5.8.2.
(9)
Remove droop current transformer, paragraph 5.8.5.
(10) Remove power potential transformer, paragraph 5.8.6.
(11) Remove current transformer, paragraph 5.8.4.
(12) Remove output box wiring harness, paragraph 5.8.3.
(13) Remove locknuts (14), screws (15), and AC circuit interrupter (16) from rear panel (33).
(14) Remove locknuts (17), screws (18), and cranking relay (19) from side panel (27).
(15) Remove locknuts (20), bolts (21), and output box panels (24, 27, and 33) from generator set.
(16) Remove locknuts (22), bolts (23), and side panel (24) from rear panel (33).
(17) Remove locknuts (25), bolts (26), and side panel (27) from rear panel (33).
(18) Remove grommets (28 and 29) from rear panel (33).
