ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
5-47
(14) Lift generator slowly from skid base. Ensure engine flywheel and generator separate smoothly,
avoiding any undue stress.
(15) Remove jamnuts (19), washers (20), bolts (21), washers (22), jamnuts (23),
plates (24), and angles (25) from generator.
(16) Remove shock mounts (26) from skid base.
b. Installation.
(1)
Position shock mounts (26, Figure 5-8) on skid base.
(2)
Install angles (25), plates (24), jamnuts (23), washers (22), bolts (21), washers (20), and jamnuts
(19) on generator. Do not tighten jamnuts.
CAUTION
Generator is heavy. Rated capacity of overhead hoist should be at least
1,000 lb. (454 kg). Failure to comply can cause damage to equipment.
(3)
Attach lifting harness to overhead hoist and generator lifting eye (27).
(4)
Position generator on skid base with mounting holes aligned to angles (25) and engine flywheel
housing.
(5)
Secure generator to engine flywheel housing with washers (13), lockwashers (12), and bolts
(11). Tighten bolts slowly to ensure proper seating of generator case lip in flywheel housing.
Torque bolts to 25 ft-lb (33.9 Nm).
(6)
Secure generator to skid base with snubbing washers (18), Belleville washers (17), bolts (16),
washers (15), and locknuts (14). Torque bolts to 210 ft-lb (284.9 Nm).
(7)
Secure generator drive disc to engine flywheel with washers (10), lockwashers (9), and bolts (8).
Torque bolts to 25 ft-lb (33.9 Nm).
(8)
Install band cover (7), washers (6), screws (5), lockwashers (4), and nuts (3) on generator.
(9)
Adjust jamnuts (19 and 23) on generator mount to obtain 0.5 in. minimum clearance between
ends of bolts (21) and skid base. Torque nuts to 150 ft-lb (203.4 Nm).
(10) Detach lifting device from generator lifting eye (27).
(11) Raise engine support brackets (2) from skid base, and tighten bolts (1).
(12) Install rear forklift guide. Refer to paragraph 5.11.1.
(13) Install load terminal board, paragraph 4.12.8.
(14) Install rear housing section, paragraph 4.7.5.
(15) Install output box assembly, paragraph 5.8.1.
