ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-200
__________
WARNING
Dry cleaning solvent is flammable and toxic to eyes, skin, and respiratory tract.
Skin and eye protection is required when working in contact with dry cleaning
solvent. Avoid repeated or prolonged contact. Work in ventilated area only.
Failure to comply can cause injury or death to personnel.
(3)
Clean magnetic pickup with dry, filtered compressed air, and wipe with a clean, lint-free cloth (Item
8, Appendix E) lightly moistened with dry cleaning solvent (Item 20, Appendix E).
(4)
Inspect magnetic pickup for cracked casing, stripped or damaged threads, corrosion, and bent or
broken connector pins.
(5)
Replace magnetic pickup if damaged.
(6).
Install magnetic pickup, 4.13.3.c.
c. Installation.
(1)
Screw magnetic pickup (4, Figure 4-30) into flywheel housing until pickup bottoms out on flywheel.
Back magnetic pickup out 1 1/2 turns. Tighten locknut (5).
(2)
Connect electrical plug connector to magnetic pickup (4). Remove tags.
(3)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
(4)
Adjust magnetic pickup (4), 4.13.3.d.
(5)
Close engine compartment access doors.
d. Testing.
(1)
Disconnect P13 from receptacle J13 at magnetic pickup. Refer to FO-1.
(2)
Set multimeter for VAC, and connect multimeter positive lead to terminal B of P13 and negative
lead to terminal A.
(3)
Set MASTER CONTROL switch to ON and crank engine with DEAD CRANK switch. Observe
multimeter. Indication should be between 1.0 and 1.5 VAC.
(4)
If indications are not as above, replace magnetic pickup. Refer to paragraph 4.13.3.
