ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-199
(1)
Apply sealing compound (Item 22, Appendix E) to threads of coolant temperature sender (2, Figure
4-30), and install switch on engine block.
(2)
Connect electrical plug connector to coolant temperature sender (2).
(3)
Add coolant/antifreeze to proper level at the filler neck (2, Figure 4-22).
(4)
Install radiator cap (1) on filler neck (2).
(5)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
(6)
Start generator set, paragraph 2.11.1. Allow unit to reach operating temperature, and check for
leaks.
(7)
Add coolant/antifreeze to overflow bottle as required.
(8)
Close engine compartment access doors.
4.13.3 Magnetic Pickup MPU.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Open BATTERY ACCESS door (Figure 1-2), and disconnect negative battery cable.
(3)
Open left side engine compartment access doors (Figure 1-3).
(4)
Disconnect electrical plug connector from magnetic pickup (4, Figure 4-30).
(5)
Loosen locknut (5), and remove magnetic pickup (4) from flywheel housing.
b. Service.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove magnetic pickup, refer to paragraph 4.13.3.a.
WARNING
Cleaning with compressed air can cause flying particles. When using
compressed air, wear protective glasses and use clean, low pressure air, less
than 30 psi (206.8 kPa). Failure to comply can cause eye injury.
