ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-194
(7)
Install bus bar (17), washers (16), and locknuts (15) on terminal studs (21 and 26).
(8)
Install load terminals (14), brass washers (13), and jamnuts (12) on load output terminal board (11).
(9)
Position load output terminal board (11) in generator set.
(10) Install varistor leads (10), electrical leads (9), brass washers (8), and locknuts (7) on load terminals
(14). Remove tags.
(11) Secure load output terminal board (11) to terminal board supports (34 and 35) with washers (6),
lockwashers (5), and bolts (4).
(12) Apply a thin coat of antiseize compound (6, Appendix E) to skid base at ground strap mating
surface.
(13) Secure ground strap (20) to skid base with lockwashers (3), bolt (2), and locknut (1). Tighten
locknut (18).
(14) Install rear housing panel. Refer to paragraph 4.7.5.
(15) Connect load output cables L1, L2, L3, and N to load output terminal board assembly, and close
load terminal board access door.
(16) Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.13
MAINTENANCE OF ENGINE ACCESSORIES.
__________
WARNING
When disconnecting or removing batteries, disconnect the negative lead that
connects directly to the grounding stud first. Disconnect the negative end of
the interconnection cable next. When installing batteries, reverse the
connection sequence. Failure to comply can cause serious personal injury.
4.13.1 Oil Pressure Sender MT7.
a. Testing.
(1)
Start generator set, paragraph 2.11.1.
(2)
Open left side engine compartment access doors (Figure 1-3).
(3)
Set multimeter to VDC. Place positive lead of multimeter on the black wire lead of the oil pressure
sender connector, and the negative lead to ground. Readings shall be between 1 and 5 VDC.
(4)
Shut down generator set, paragraph 2.11.2.
(5)
If indications are not as above, replace oil pressure sender (1), refer to paragraph 4.13.1. b and d.
