ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-72
(13) Install front housing (14), washers (13), lockwashers (12), and bolts (11) on skid base.
(14) Secure front housing (14) to skid base with bolts (10), washers (9), lockwashers (8), and nuts (7).
(15) Install bolts (6), washers (5), lockwashers (4), and nuts (3) on front housing (14) and door sills (22
and 23).
(16) Position ground rod sections (2) in brackets (56), and install bolts (1).
(17) Install top housing section, paragraph 4.7.3.
(18) Install engine compartment access doors. Refer to paragraph 4.7.1.
(19) Install BATTERY ACCESS door. Refer to paragraph 4.7.1.
(20) Install NATO SLAVE RECEPTACLE, paragraph 4.6.4, and batteries, paragraph 4.6.3.
4.7.5
Rear Housing Section.
a. Removal.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box assembly, paragraph 4.8.1.
(3)
Remove air cleaner assembly, paragraph 4.9.2.
(4)
Remove output box access door, load terminal board access door, rear engine compartment access
doors, and air cleaner access door. Refer to paragraph 4.7.1.
(5)
Remove fuel tank filler neck, paragraph 4.11.3.
(6)
Remove auxiliary fuel pump, paragraph 4.11.2.
(7)
Remove ether solenoid valve, paragraph 4.11.8.
(8)
Remove top housing panel. Refer to paragraph 4.7.3.
(9)
Remove output box. Refer to paragraph 5.8.
(10) Remove nuts (1, Figure 4-9), lockwashers (2), washers (3), and bolts (4) from rear panel (8) and
skid base.
(11) Remove bolts (5), lockwashers (6), washers (7), and rear panel (8) from corner post (40) and left
side rear panel (19).
(12) Remove locknuts (9), bolts (10), and load terminal access box (11) from rear panel (8).
(13) Remove nuts (12), lockwashers (13), washers (14), and bolts (15), from left side rear panel (19) and
engine compartment door sill (61).
(14) Remove bolts (16), lockwashers (17), washers (18), and left side rear panel (19) from skid base.
