ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-71
c. Repair.
__________
WARNING
CARC paint is a health hazard. Wear protective eyewear, mask and gloves
when sanding CARC painted surfaces. Failure to comply can cause personal
injury.
(1)
Repair all dents and cracks, and remove loose paint.
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
(4)
Replace stripped or cracked cage nuts (57 through 62, Figure 4-8).
(5)
Replace damaged insulation (25) and missing or damaged clip halves (24 and 63) or push-on nuts
(64).
(6)
Replace damaged seals (65 through 67). Refer to Table E.
(7)
Replace damaged or unreadable identification plates (68, 70, and 72).
(8)
Replace loose or missing rivets (69, 71, and 73).
d. Installation.
(1)
Install brackets (56, Figure 4-8), bolts (55), and locknuts (54) on front housing (14) and door sill
(22).
(2)
Install SLAVE RECEPTACLE box (53), bolts (52), and locknuts (51) on front housing (14).
(3)
Install support channel (50), bolts (49), and locknuts (48) on front housing (14).
(4)
Install support (47), bolts (46), and locknuts (45) on panel (44).
(5)
Install panel (44), washers (43), lockwashers (42), and bolts (41) on front housing (14).
(6)
Install supports (39 and 40), bolts (38), and locknuts (37) on radiator panels (35 and 36).
(7)
Install radiator panels (35 and 36), washers (34), lockwashers (33), and bolts (32) on front housing
(14).
(8)
Install air deflector (31), washers (30), lockwashers (29), and bolts (28) on front housing (14).
(9)
Secure air deflector (31) to front housing (14) with bolts (27) and locknuts (26).
(10) Install insulation (25) on front housing (14) with panel clips (24), clip halves (63), and push-on nuts
(64).
(11) Install door sills (22 and 23), washers (21), lockwashers (20), and bolts (19) on skid base.
(12) Secure door sills (22 and 23) to generator set with bolts (18), washers (17), lockwashers (16), and
nuts (15).
