ARMY TM 9-6115-671-14
AIR FORCE TO 35C2-3-446-32
MARINE CORPS TM 09249A/09246A-14
4-67
(2)
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix E).
(3)
Repaint surfaces in accordance with TM 43-0139.
(4)
Replace cage nuts (67 through 75, Figure 4-7) that are stripped or cracked.
(5)
Replace damaged insulation (53 through 63, 65, and 66).
(6)
Replace missing or damaged clip halves (52, 64, 76, and 78) and push-on nuts (77 and 79).
(7)
Replace damaged seal (80) or door seals (81 and 82). Refer to Appendix E.
d. Installation.
(1)
Install insulation (65 and 66, Figure 4-7) on side panels (35 and 36) with clip halves (64).
(2)
Install insulation (53 through 63) on top panel (12) with clip halves (52).
(3)
Install angle (51) on generator set with bolts (50) and locknuts (49). Close output box access door.
(4)
Install bracket (48), bolt (47), and locknut (46) on angle (51).
(5)
Install side panels (35 and 36), bolts (45), and locknuts (44) on floor panel (37).
(6)
Install support (43), bolts (42), and locknuts (41) on front panel (40).
(7)
Install front panel (40), bolts (39), and locknuts (38) on floor panel (37).
(8)
Position side panels (35 and 36) with floor panel (37) on generator set.
(9)
Secure front panel (40) to generator set with washers (34), lockwashers (33), and bolts (32).
(10) Secure side panels (35 and 36) to generator set with washers (31), lockwashers (30), and bolts (29).
(11) Secure side panels (35 and 36) to generator set with bolts (28) and locknuts (27).
(12) Install duct panel (26), bolts (23 and 25), and locknuts (22 and 24) on floor panel (37) and side
panels (35 and 36).
(13) Install air duct channels (20 and 21), bolts (19), and locknuts (18) on floor panel (37).
(14) Install muffler. Refer to paragraph 4.9.1.
(15) Install roof stiffener assembly (17), washers (16), lockwashers (15), and bolts (14) on side panels
(35 and 36).
(16) Position radiator fill panel (13) on generator set, and connect radiator fill hose and overflow hose to
panel.
(17) Install top housing panel (12), washers (8 and 11), lockwashers (7 and 10), and bolts (6 and 9) on
generator set.
(18) Install exhaust cover (5), mount (4), washers (3), lockwashers (2), and bolts (1) on top housing
panel (12).