ARMY TM 9-6115-670-14&P
4-79
p. Reconnect connector J7 (6) to connector P7 (7).
q. Bleed the fuel system (para 4.29.).
REPAIR
a. Cut wire ties.
b. Perform STEPS a through e of REPLACE.
c. Refer to Figure FO-1 (WIN-T) or FO-7 (JTACS) and disconnect connector J7 (6, Figure 4-19) from
connector P7 (7).
d. Remove both low-level cut-off switches (5).
e. Apply sealing compound to threads of both new low-level cut-off switches (5) and install switches.
f. Connect line from transfer pump (12) to fitting (10), and secure with clamp (11).
g. Reconnect connector J7 (6) to connector P7 (7).
h. Replace wire ties.
i. Reinstall radiator support bracket (3) securing with two bolts and lock and flat washers (1) and two
screws and flat and lock washers (2).
j. Replace cable ties as required.
k. Bleed the fuel system (para 4.29.).
REPLACE
NOTE
When removing low-level cut-off switches, use a suitable
container to catch fuel leaking from disconnected fuel
lines.
CAUTION
Take care not to cut wires or other APU components
when removing tiedown straps.
NOTE
Cut and remove tiedown straps as needed to remove
wiring harness.
