ARMY TM 9-6115-670-14&P
4-83
4.33. FUEL DAY TANK ASSEMBLY (SICPS).
This task covers:
a. Service
b. Test
c. Repair
d. Replace
INITIAL SETUP
Shop Equipment, Electrical Repair,
Semi trailer Mounted
(Item 3, Appendix B)
Hand Siphon
(Item 22, Appendix B)
Gloves, Chemical and Oil Protective
(Item 34, Appendix B)
Materials/Parts
Low Level Cut-off Switch
Sealing Compound 88-20595-2
(Item 18, Appendix F)
Approved Solvent
Equipment Conditions
Engine stopped and allowed to cool completely.
MASTER ON-OFF switch on APU control unit set to
OFF.
SERVICE
a. Remove two bolts and flat and lock washers (1, Figure 4-20) and two screws and flat and lock
washers (2), and remove radiator support bracket (3).
b. Loosen clamp (18) and remove line (19) between fuel pump assembly and fuel day tank assembly
from fitting (16) at fuel intake hole (6).
WARNING
Ensure that NO IGNITION SOURCE is within 50 feet
of the 10 kW APU. The fuel in this APU is highly
flammable. Do not smoke. Do not splash fuel on hot
components. Failure to heed this warning could
result in serious injuries or DEATH.
WARNING
Avoid fuel contact with skin. Wear protective gloves,
goggles, apron and mask, while disconnecting fuel
lines.
NOTE
When disconnecting fuel lines, use a suitable
container to catch fuel from disconnected fuel lines.
NOTE
Cut and remove tiedown straps as needed to remove
wiring harness.
NOTE
When removing, make note of tiedown strap locations.
Wiring harness will need to be secured at approximately
the same places.
CAUTION
Take care not to cut wires or other APU components
when removing tiedown straps.