TM 9-6115-664-13&P
4-33.
FLOAT VALVE HOUSING ASSEMBLY MAINTENANCE
This task covers inspection and repair.
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
Fuel Module Removed (Para. 4-30)
and Repair (Item 1, App. B)
Parts/Materials:
Sealant, Thread (Item 4, App. E)
A.
REMOVAL
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Remove fuel module front plate (1, Figure 423) from
enclosure
(2)
by
removing
four
screws
(3),
lockwashers (4), washers (5), and two screws (6).
2.
Tag and disconnect two fuel hoses (10) from rear of
bulkhead fittings (7).
3.
Disengage electrical connector (8) from front plate
(1).
4.
Tag and disconnect electrical cables from rear of
feed-thru studs (9) by removing stud nuts and
washers.
5.
Disconnect fuel hose (14) from fuel pump.
6.
Remove float valve housing assembly (13) from
enclosure (2) by removing screws (36), locknuts
(21), and washers (22).
7.
Disconnect fuel hose (13) and elbow (11) from
housing assembly (37). Remove hose clip (12) only
if replacement is required.
Figure 4-23. Float Valve Housing (Sheet 1 of 4)
4-82
