(5)
(6)
(7)
(8)
(9)
( l o)
(11)
(12)
(13)
(14)
(15)
(16)
TM 9-6115-650-14&P
Install and tighten two screws (18) and two flat washers (19) securing each of two front trailer body
support brackets (21) to trailer frame (22).
Install and tighten 12 screws (18), 24 flat washers (19) and 12 nuts (20) securing remaining trailer body
support brackets (21) to trailer frame (22).
Insert one lifting ring (17) into each of two mounting holes in trailer body (13) and secure with one flat
washer (16) and one nut (15). Install one cotter pin (14) in each nut and spread cotter pin ends.
Position two generator set mounting rails (12) on trailer body (13). Insert eight screws (9) with eight flat
washers (10) through each mounting rail and through trailer bed and frame (22).
Working under trailer, install one flat washer (10) and one nut (11) on each of 16 mounting rail screws
(9) and tighten.
Position one composite light (5) on each rear mounting bracket (8) and secure each light with two screws
(6) and two Iockwashers (7).
Working under trailer, connect one composite light cable assembly (3) to each composite light (5) by
plugging four cable assembly connectors into four composite light connectors (4). Plug four connectors
at opposite end of each cable assembly into four connectors (1) on trailer main wiring harness (2).
Install both generator sets (paragraph 5-7, b.).
Install switch box (paragraph 4-24, b.).
Install accessory box (paragraph 4-19, b.).
Install six bows (paragraph 3-11, b(2)).
Install fitted cover (paragraph 3-11, a(2)).
5-4. Fitted Cover Repair. Repairs to the fitted cover shall be made in accordance with FM 10-16, Fabric
Repairing.
5-5. Accessory BOX Repair. (See figure 5-4.) The accessory box is repaired by replacing the hasp, the
catches and the footmans loops, as required. The box itself may be straightened, welded, and repainted. If
required, repaint in accordance with MIL-T-704, Type F, color Green, No. 383 of MIL-C-46168. If power plant is
painted in camouflage, refer to paragraph 5-6, Marking.
a.
Catch and Hasp Replace ment.
(1) Grind off or drill out solid rivets (1) securing catch or hasp (2) to accessory box (3).
(2) Position new catch or hasp (2) on accessory box and secure with solid rivets (1).
(3) Touch up with paint as required.
5-7
