TM 9-6115-650-14&P
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
5-4
Remove bow assemblies (paragraph 3-11, b.(1)).
Remove accessory box (paragraph 4-19, a.)
Remove switch box (paragraph 4-24, a.).
Remove both generator sets (paragraph 5-7, a.).
Working under trailer, unplug four connectors (1) joining trailer main wiring harness (2) to roadside
composite light cable assembly (3), and four connectors (4) joining cable assembly to composite light
(5).
Repeat step (6) for curbside composite light cable assembly.
Remove two screws (6) and two Iockwashers (7) securing each composite light (5) to its bracket (8) and
remove both composite lights.
Remove eight screws (9), 16 flat washers (10) and eight nuts (11) securing each generator mounting rail
(12) to trailer body (13) and remove both rails.
Remove cotter pin (14), nut (15) and flat washer (16) from each of two trailer lifting rings (17) and
remove lifting rings.
NOTE
The two trailer body support brackets located at the front of the trailer are secured with
only two screws and two flat washers each.
Working under trailer, remove 16 screws (1 8), 28 flat washers (19) and 12 nuts (20) securing trailer body
support brackets (21) to trailer frame (22).
NOTE
There are 18 short screws and four long screws securing trailer body to trailer frame.
Since corner screws must extend through trailer frame rails, corner mounting locations
require longer screws (step (13)).
Remove 18 screws (23), 36 flat washers (24) and 18 nuts (25) securing trailer body (13) to trailer
frame (22).
Remove four long screws (26), eight flat washers (27) and four nuts (28) securing trailer body (13) to
trailer frame (22) at corner mounting locations.
