TM 9-6115-650-14&P
(6) Disconnect external fuel line (9), if connected.
WARNING
When lifting generator set, use lifting equipment with a minimum lifting capacity of 1500
lb. Do not stand under generator while it is being lifted. Failure to observe these
precautions can cause injury to personnel or damage to equipment.
(7) Attach lifting equipment with a minimum lifting capacity of 1500 lb (1, figure 5-7) to lifting eye (2) on top
of generator set (3) and remove generator set from trailer.
b. Installation.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
WARNING
When lifting generator set, use lifting equipment with a minimum lifting capacity of 1500
lb. Do not stand under generator while it is being lifted. Failure to observe these
precautions can cause injury to personnel or damage to equipment.
Attaching lifting equipment with a minimum lifting capacity of 1500 lb (1, figure 5-7) to lifting eye (2) on
top of generator set (3) and lift generator.
Lower generator set (2, figure 5-6) onto mounting rails (6) on trailer bed (7) and aline mounting holes.
Insert four screws (3), with four Iockwashers (4) and four beveled washers (5), down through generator
set skid into nuts welded to underside of mounting rails (6).
Position beveled washers (5) so that screw heads are parallel to tops of washers. While holding beveled
washers in position, tighten hardware to secure generator set (2) to mounting rails (6).
Insert engine oil drain hose (8) through grommet in trailer bed
Install six bow assemblies (paragraph 3-11, b.(2)).
Install fitted cover (paragraph 3-11, a.(2)).
7).
Section IV. MAINTENANCE OF ELECTRICAL SYSTEM
5-8. Switch Box Repair. (See figure 5-8.) Repairs to the switch box require disconnecting wires. When
reconnecting wires, refer to the schematic (figure 4-7) inside the switch box.
WARNING
Make sure generator set circuit breakers are in OFF position before performing any
repairs on switch box. Failure to observe this precaution may result in injury or death by
electrocution.
5-11
