TM 9-6115-647-14&P
(6)
Remove screw (12), lockwasher (13) and flat washer (14) and remove ground wire (15) from
fuel tank (2).
(7)
Loosen nut (16) on fuel tank vent tube (17) and remove vent tube from fuel tank (2).
NOTE
Vibration isolators are not identical Mark each for location and position before
removing.
(8)
Remove six screws (18), twelve flat washers (19) and six self-locking nuts (20) and remove
fuel tank (2) and three vibration isolators (21) from trailer cross-members (22).
(9)
Remove drain cock (1) from fuel tank (2).
b.
Installation.
NOTE
If fuel line was removed but not fuel tank, omit steps (1) through (6).
(1)
Install drain cock (1) in bottom of fuel tank (2) Close drain cock.
NOTE
Observe location and position marks on vibration isolators when installing.
(2)
Position three vibration isolators (21) and fuel tank (2) on trailer cross-members (22) and
fasten with six screws (18), twelve lockwashers (19) and six self-locking nuts (20). Tighten
screws until each vibration isolator is compressed to a thickness of 0 090 inch (O 229
centimeters).
(3)
Install fuel tank vent tube (17) on fuel tank hydraulic tube fitting (23) and tighten nut (16).
(4)
Attach ground wire (15) to fuel tank (2) with screw (12), lockwasher (13) and flat washer (14).
(5)
Plug P4 connector on fuel cable (10) into fuel level sensor (11) on fuel tank (2).
(6)
Install front and middle-front generator set supports (7) (paragraph 5-16). Make sure front
support is positioned so that P4, P7 fuel cable clamp mounting hole is on curbside, and that
middle-front support is positioned so that fuel line clamp mounting holes are In middle and
curbside.
(7)
Install fuel line (6) on fuel tank connector (24) and tighten fitting (8). Slide three loop clamps
(5) onto fuel line, position over mounting holes in generator set supports (7) and fasten each
clamp with one screw (3) and one lockwasher (4). Pull free end of fuel line up through
curbside walkway (9).
(8)
Install generator set (paragraph 5-2).
(9)
Fill fuel tank (2) and check for leaks.
5-19
