m.
h.
i.
j.
k.
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
Governor actuator bracket (18, FIGURE 4-8) with governor actuator (11) and linkage, and DEAD CRANK
switch (11, FIGURE 2-30) attached. Use hardware from old engine.
Either start spray nozzle (9, FIGURE 2-27).
Oil pressure sender (2, FIGURE 2-30).
Coolant drain valve (3, FIGURE 2-30).
Coolant temperature sender (4, FIGURE 2-30).
Coolant high temperature switch (5, FIGURE 2-30).
Magnetic pickup (6, FIGURE 2-30). Screw into flywheel housing until magnetic pickup bottoms out, back
out 1-1/2 turns and tighten jam nut.
Diode assembly (13, FIGURE 2-30). Install with band end toward engine.
Fan belt (6, FIGURE 2-25).
Install new engine in generator set, paragraph 3-7-2.
Check and adjust governor actuator as necessary, paragraph 4-15-4.
Check and adjust magnetic pickup as necessary, paragraph 2-110-4.
Check and adjust fan belt as necessary, paragraph 2-84-2.
Start generator set, check for leaks and proper operation.
3-29/(3-30 blank)
