ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
2-88
FUEL TANK FILLER NECK.
2-88-1
a.
b.
REMOVAL.
Shut down generator set.
Open battery access door and disconnect negative battery cable.
c.
d.
e.
f.
g.
h.
i.
j.
2-88-2
a.
b.
c.
d.
e.
f.
2-88-3
a.
b.
c.
d.
e.
f.
g.
h.
2-132
Diesel fuel is flammable and toxic to eyes, skin, and respiratory tract. Skin/eye protection
required. Avoid repeated/prolonged contact. Good general ventilation is normally ade-
quate.
Remove cap (27, FIGURE 2-26), open fuel drain valve (29) and drain fuel into suitable container.
Open left side engine access doors.
Remove filler neck cap and tube assembly (14).
Loosen clamp (15) and disconnect hose (16) from adapter (17).
Remove adapter (17) from fitting (18).
Remove nut (19), washer (20), and fitting(18) from side of filler neck (23).
Remove bolts (21) and nuts (22) securing filler neck (23) to generator set housing.
Remove clamps (24) and (25), hose (26), and filler neck (23) from fuel tank opening. Cover fuel tank opening.
Inspection.
Shut down generator set.
Remove fuel tank filler neck, paragraph 2-88-1.
Inspect hose (26, FIGURE 2-26) for cracking, wear, or other damage.
Inspect filler neck (23) for corrosion, cracking, or other damage.
Inspect filler neck cap and tube assembly (14) for damage.
Install fuel tank filler neck, paragraph 2-88-3.
Position hose (26, FIGURE 2-26), clamps (24) and (25), and filler neck (23) on fuel tank.
Install bolts (21) and nuts (22) securing filler neck (23) to generator set housing.
Tighten clamps (24) and (25).
Install fitting (18), washer (20), and nut (19) in side of filler neck (23).
Install adapter (17) on fitting (18) and connect hose (16) to adapter (17) with clamp (15).
Install filler neck cap and tube assembly (14).
Close fuel drain valve (29), install cap (27), and service fuel tank Refer to TABLE 2-2 for proper fuel.
Connect negative battery cable. Close battery access door and engine access doors.
Installation
