b.
c.
d.
2-75-3
a.
b.
c.
d.
e.
f.
g.
h.
i.
2-75-4
a.
b.
c.
d.
e.
f.
g.
h.
i.
ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
Clean air cleaner tubing and breather housing with cleaning cloth (Item 8, Appendix C) dampened with dry clean-
ing solvent (Item 20, Appendix C).
Replace breather element.
Install air cleaner tubing and breather, paragraph 2-75-4.
Removal.
Shut down generator set.
Open engine access doors.
Loosen clamps (2 and 18, FIGURE 2-21).
Remove hose (15) from air cleaner housing (7) and tube (16).
Remove tube (16) from breather hose (19) and hump hose (17).
Remove hump hose (17) from turbocharger.
Remove breather hose (19) from breather (20).
Remove breather (20) from valve cover.
Remove wing nut (21), washer (22), cover (23), rubber seal (24), and element (25) from breather (20).
Install element (25, FIGURE 2-21 ), rubber seal (24), cover (23), washer (22), and wing nut (21) on breather (20).
Install breather (20) in valve cover.
Install hose (19) and clamp (18) on breather (20).
Install hump hose (17) and clamp (2) on turbocharger.
Install tube (16) and clamp (2) on hump hose (17).
Install breather hose (19) and damp (18) on tube (16).
Install hose (15) and clamps (2) on tube (16) and air cleaner housing (7).
Tighten clamps (2) and (18).
Close engine access doors.
Installation
Section XII. MAINTENANCE OF COOLANT SYSTEM
2-76
COOLANT SYSTEM.
2-76- 1 Testing
a. Shut down generator set.
WARNING
Coolant can get very hot. Allow system to cool down before performing maintenance.
Failure to follow these instructions could result in severe bums and injuries.
2-115
