e.
f.
g.
h.
i.
j.
2-70-2
a.
b.
2-70-3
a.
b.
c.
d.
ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
Remove control box side panels, paragraph 2-69-1.
Remove control box components, paragraphs 2-42 through 2-50,2-52 through 2-61,2-65, and 2-66.
Contact Direct Support Maintenance to remove AC voltage regulator and control box harness.
Remove screws (34, FIGURE 2-19) and bracket (35) from control box bottom (42).
Remove screws (36), nuts (37), and relay tracks (38) from control box bottom (42).
Remove screws (39), nuts (40), and latch plate (41) from control box bottom (42).
Inspection.
Inspect control box bottom (42, FIGURE 2-19) for dents, cracks, loose paint, and corrosion.
Inspect for missing or damaged cage nuts (43).
Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC paint
dust is a health hazard and could cause personal injury if warning is not followed.
Repair ail dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
Replace missing or damaged cage nuts.
2-107
