ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
2-70-4 Installation.
a.
Install latch plate (41, FIGURE 2-19) on control box bottom (42) with screws (39) and nuts (49).
b.
Install relay tracks (38) on control box bottom (42) with screws (36) and nuts (37).
c.
Install bracket (35) on control box bottom (42) with screws (34).
d.
Contact Direct Support Maintenance to install control box harness and AC voltage regulator.
e.
Install control box components, paragraphs 2-42 through 2-50, 2-52 through 2-61, 2-65, and 2-66.
f.
Install control box side panels, paragraph 2-69-4.
g.
Install control panel frame, paragraph 2-68-4.
h.
Install control box assembly, paragraph 2-19-4.
i.
Connect negative battery cable and close battery access door.
Section Xl. MAINTENANCE OF AIR INTAKE AND EXHAUST SYSTEM
2-71
MUFFLER AND EXHAUST PIPE.
2-71-1
a.
b.
c.
d.
e.
f.
g.
2-71-2
a.
b.
c.
d.
e.
f.
Removal.
Shut down generator set.
Remove top housing panel and top housing frame, paragraph 2-16-1 and open engine access doors.
WARNING
The exhaust system can get very hot. Allow system to cool before performing mainte-
nance. Failure to follow these instructions could result in severe bums and injuries.
Remove clamp (1, FIGURE 2-20).
Open bands (2) and separate muffler (3) and pipe (4). Remove muffler (3) from generator set.
Remove bolts (5), lockwashers (6), washers (7), nuts (10), and muffler supports (8).
Loosen exhaust pipe clamp (9) at turbocharger outlet.
Remove left side air deflector and sufficient hardware securing top section floor panel, paragraph 2-16-1. to al-
low removal of exhaust pipe (4) from generator set.
Inspection.
Shut down generator set.
Remove top housing panel and top housing frame, paragraph 2-16-1.
Open engine access doors.
Inspect muffler (3, FlGURE 2-20) and pipe for cracks, excessive corrosion, clogging, and other damage.
Replace damaged parts.
Install top housing frame and top housing panel, paragraph 2-16-4. Close engine access doors.
Change 1
2-109
