ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
(2)
Mechanical governor on rear of fuel Injection pump
(3)
Filter element for engine mounted fuel filter.
c.
Remove the following from old engine and install on new engine:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Oil sample valve, low oil pressure switch, and fitting assembly (1, FIGURE 3-16).
Loop clamp (2, FIGURE 3-16) Use hardware from old engine.
Fuel filter fitting (3, FIGURE 3-16).
Fuel transfer pump fittings (4, FIGURE 3-16).
Oil pressure sender and fitting assembly (5, FIGURE 3-16).
Radiator support bracket (6, FIGURE 3-16). Use hardware from old engine.
Glow plug contactor (12, FIGURE 2-13) and mounting bracket (15). Use hardware from old engine
Exhaust adapter (12, FIGURE 2-20) and gasket (13). Use hardware from old engine.
Governor actuator and fuel Injection pump interface plate, paragraph 4.14.2.
(10) Coolant drain valve (1, FIGURE 2-32).
(11) Coolant temperature sender (3, FIGURE 2-31).
(12) Coolant high temperature switch (2, FIGURE 2-32).
(13) Magnetic pickup (4, FIGURE 2-31). Screw into flywheel housing until magnetic pickup bottoms out, back out
1-1/2 turns and tighten jam nut.
(14) Fan belt (6, FIGURE 2-25).
(15) Lower starter mounting bolt Bolt replaces stud in new engine.
d.
Install new engine in generator set, paragraph 3.7.2.
e.
Check and adjust magnetic pickup as necessary, paragraph 2.108.4.
f.
Check and adjust fan belt as necessary, paragraph 2.83.2.
g.
Start generator set, check for leaks and proper operation.
3-27
