ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
NOTES:
1. Dimensions shown are in inches.
2. Refer to TM 9-115-642-24P for materials required.
PROCEDURES:
1. Cut wire (1) to length indicated.
2. Strip 0.75 inch of insulation from each end of wire (1).
3. Position insulation sleeving (2) on center of wire, mark with wire number "108A2” and shrink to fit.
4. Mark insulation sleeving (3) with “POSITIVE” and sIide over one end of wire (1).
5. Mark insulation sleeving (4) with “NEGATIVE” and slide over one end of wire (1).
6. Crimp and solder terminal (5) on end of wire (1) with insulation sleeving (3). Install with bolt orientation as shown and
battery post hole tapering open to far side.
7. Crimp and soIder terminal (6) on end of wire (1) with insulation sleeving (4). Install with bolt orientation as shown and
battery post hole tapering open to far side.
8. Position insulation sleeving (3) and (4) as shown and shrink to fit.
FIGURE D-3. Cable Assembly, Battery (P/N: 88-20314)
D-4
