ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
g.
Install resistor-diode assembly, paragraph 2-34.5; relays, paragraph 2-33.4; crank disconnect switch, para-
graph 2-32.4; short circuit/overload relay, paragraph 2-31.4; overvoltage relay, paragraph 2-30.4; shunt, para-
graph 2-29.4; frequency transducer, paragraph 2-28.5; AC voltage regulator, paragraph 2-27.4; BATTERY
CHARGER FUSE assembly, paragraph 2-25.4; and DC CONTROL POWER circuit breaker, paragraph
2-26.4.
h. Install control box side panels, paragraph 2-56.4; control panel frame, paragraph 2-55.4; control panel, para-
graph 2-54.4; and control box top panel, paragraph 2-16.4.
i.
Connect negative battery cable and close access door.
SECTION XI. MAINTENANCE OF OUTPUT BOX ASSEMBLY
2-58 OUTPUT BOX ASSEMBLY.
a.
Shut down generator set.
b. Remove control box top panel, paragraph 2-16.1.
c.
Inspect output box panels and tray for cracks, dents, loose paint, and corrosion.
d. Install control box top panel, paragraph 2-16.4.
2-58.2 Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
a.
Repair all dents and cracks, and remove all loose paint.
b. Remove light corrosion with fine abrasive paper (Item 15, Appendix C).
c.
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
2-59 OUTPUT BOX/ENGINE HARNESS.
2-59.1
a.
b.
c.
d.
e.
f.
g.
h.
2-59.2
a.
b.
2-86
Shut down generator set.
Remove control box top panel, paragraph 2-16.1.
Open engine access doors.
Inspect wiring harness (1, FIGURE 2-16) for burned, bent, corroded, and broken terminals.
Inspect connectors for cracks, corrosion, stripped threads, bent or broken pins, and obvious damage.
Inspect wire insulation for bums, deterioration, and chafing.
Install control box top panel, paragraph 2-16.4.
Close engine access doors.
Repair.
Replace damaged or broken terminals.
Replace damaged or broken connector pins.
Inspection.
2-58.1 Inspection.
