ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
2-55.4
a.
b.
c.
d.
e.
f.
Install control panel frame (12, FIGURE 2-15) on control box assembly with bolts (8) and (10), and nuts (9)
and (11).
Install malfunction indicator panel, paragraph 2-24.4.
Install ground fault circuit interrupter, paragraph 2-23.4.
Install convenience receptacle, paragraph 2-22.4, and diagnostic connector, paragraph 2-36.3.
Install control panel, paragraph 2-54.4 and control box top panel, paragraph 2-16.4.
Connect negative battery cable and close access door.
2-56 CONTROL BOX SIDE PANELS.
2-56.1 Inspection.
a.
Inspect control box side panels (15 and 16, FIGURE 2-15) for dents, cracks, loose paint, and corrosion.
b. Inspect for missing and damaged cage nuts (17).
2-56.2 Removal.
a.
Shut down generator set.
b. Open left engine access door and disconnect negative battery cable.
c.
Remove control box top panel, paragraph 2-16.1.
d. Remove bolts (8 and 13, FIGURE 2-15) and nuts (9) and (14).
e.
Remove control box side panels (15) and (16).
2-56.3 Repair.
a.
b.
c.
d.
2-56.4
a.
b.
c.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
Replace damaged and missing cage nuts (17).
Install control box side panels (15 and 16, FIGURE 2-15) with bolts (8) and (13), and nuts (9) and (14).
Install control box top panel, paragraph 2-16.4.
Connect negative battery cable and close access door.
2-83
I n s t a l l a t i o n.
Installation.