ARMY TM 9-6115-642-24
AIR FORCE TO 35C2-3-455-12
MARINE CORPS TM 09247A/09248A-24/2
2-54.3
a.
b.
c.
2-54.4
a.
b.
c.
d.
e.
f.
Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
Install hinge (6, FIGURE 2-15) on control panel (7) with bolts (4) and nuts (5).
Install control panel (7), with hinge (6) attached, on control box with bolts (4) and nuts (5).
Install strap (3) with screw (1) and nut (2).
Connect electrical leads to all indicators and switches and remove tags.
Raise and secure control panel.
Connect negative battery cable and close access door.
2-55 CONTROL PANEL FRAME.
2-55.1 Removal.
a.
Shut down generator set.
b. Open left engine access door and disconnect negative battery cable.
c.
Remove control box top panel, paragraph 2-16.1.
d. Remove control panel, paragraph 2-54.2.
NOTE
It is not necessary to disconnect electrical leads for components removed in steps
e thru g.
e.
Remove diagnostic connector, paragraph 2-36.2.
f.
Remove convenience receptacle, paragraph 2-22.3.
g.
Remove ground fault circuit interrupter, paragraph 2-23.3.
h. Remove malfunction indicator panel, paragraph 2-24.3.
i.
Remove bolts (8 and 10, FIGURE 2-15), nuts (9) and (11), and control panel frame (12).
2-55.2 Inspection.
Inspect control panel frame (12, FIGURE 2–15) for dents, cracks, loose paint, and corrosion.
2-55.3 Repair.
WARNING
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personal injury if warning is not
followed.
a.
Repair all dents and cracks, and remove all loose paint.
b. Remove light corrosion with fine grit abrasive paper (Item 15, Appendix C).
c.
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
2-82
Installation.
