ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
An unwrapped exhaust pipe can cause injury if touched.
g. Wrap exhaust pipe in protective material.
2-3. FABRICATION/ASSEMBLY OF PARTS.
Table 2-4 is a list of generator parts that require fabrication or assembly when replacing. See Appendix D for fabrication
and assembly instructions.
Table 2-4. Fabricated/Assembled Parts
NAME
PART NUMBER
Cable Assembly, Battery
88–20312
Cable Assembly, Battery
88–20313
Cable Assembly, Battery
88–20314
Cable Assembly, Battery
88–20315
Cable Assembly, Battery
88-20316
Cord, Load Wrench
88–22460
Diode Assembly
88-22418-1
Holder, Control Panel
88–20134
Insulation, Skid
88–20296
Pump Assembly, Fuel
88–20479
Pump Assembly, Fuel
88–22546
Solenoid Assembly, Fuel
88-20482
Transducer Assembly
88–20480
Wire, Varistor (L0)
88–20305-1
Wire, Varistor (L1)
86-20305-2
Wire, Varistor (L2)
88–20305–3
Wire, Varistor (L3)
88-20305-4
Section Il. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SPECIAL SUPPORT EQUIPMENT
2-4.
REPAIR PARTS AND SPECIAL TOOLS LIST (R PSTL).
2-4-1. Tools and Equipment. There are no special tools or support equipment required to perform unit level maintenance
on the generator set. A list of recommended tools and support equipment required to maintain the generator set is con-
tained in Appendix B, Section Ill.
2-4-2. Maintenance Repair Parts. Repair parts and equipment are listed and illustrated in the repair parts and special
tools list manual TM 9–6115–641–24P.
Section Ill. SPECIAL LUBRICATION INSTRUCTIONS
NOTE
There are no special lubrication instructions, refer to LO 9–6115–641–12 for generator
set lubrication requirements.
2-7
