TM 5-6115-631-14&P
i. Attach power unit to towing vehicle. (Refer to TM 9-2330-213-14&P.)
4-4.
Reinstallation After Movement. After movement to a new worksite, install power plant in
accordance with paragraph 4-2.
Section Ill. REPAIR PARTS, SPECIAL TOOLS, SPECIAL TEST, MEASUREMENT AND
DIAGNOSTIC EQUIPMENT (TMDE)
4-5. Tools and Equipment. There are no special tools or equipment required to maintain the
AN/MJQ-16 power plant.
4-6.
Maintenance Repair Parts. Repair parts and equipment for maintenance of this power plant are
listed and illustrated in the repair parts and special tools list in Appendix D of this manual.
Section IV. LUBRICATION INSTRUCTIONS
4-7. General. Detailed instructions for the lubrication of the major components of the power plant are
contained in the applicable Lubrication Orders (LO’s). Refer to DA Pam 25-30 to ensure that the latest
editions of the L.O.’S are used. This section contains lubrication instructions that are not included in
the Lubrication Orders.
4-6. Generator Lubrication. Refer to LO 5-6115-584-12 for generator set Lubrication Order.
4-9. Trailer Assembly Lubrication.
a. Trailer Lubrication. Refer to TM 9-2330-213-14&P for trailer Lubrication Order.
b. Leg Prop Assembly Lubrication. The rear leg prop assembly is a modification to the standard
M103A3 trailer and, as such, does not appear in the associated L.O. Semiannually lubricate leg prop
assembly as follows:
WARNING
Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and
prolonged exposure of skin to cleaning solvent. Wash exposed skin tho-
roughly. Dry cleaning solvent (P-D-680) used to clean parts is potentially
dangerous to personnel and property. Do not smoke or use near open flame or
excessive heat. Flash point of solvent is 100°F. to 138°F. (38°C. to 59°C.).
(1) Clean hydraulic lubrication fitting and area around lubrication points with P-D-680 or
equivalent.
(2) Inject sufficient GAA grease into hydraulic fitting to lubricate screw theads inside leg prop
assembly.
NOTE
Refer to Lubrication Instructions in TM 9-2330-213-14&P for lubricating oils
specified for use within different anticipated temperature ranges.
(3) Apply OE lubricating oil to both ends of leg prop assembly pivot shaft.
4-7
