TM 5-6115-631-14&P
Figure 4-2.Installing Power Plant
WARNING
Do not operate generator sets until power plant is properly grounded
(paragraph 4-2, b.). Serious injury or death by electrocution can result from
operating an ungrounded power plant.
CAUTION
To avoid damage to equipment, make certain of voltage, frequency, and
phase requirements of load being connected to generator set.
(6) Refer to data plate on load terminal board cover and to TM5-6115-584-12. Connect power
plant to system or equipment to be powered.
b. Grounding. Check that generator sets are grounded to GROUND TERMINAL stud on trailer
body. Using ground wire supplied, connect power plant to a suitable ground as described below. The
following sources of a good ground are listed in order of preference.
NOTE
As a substitute for the supplied ground wire, any copper wire of at least No. 6
AWG maybe used.
4-4
