(a) Position switch (9) in switch box (5), making certain it is right side up, and secure with six screws (10),
six flat washers (12) and six Iockwashers (11).
(b) Install six wires (8) on switch (9) and secure each with one nut (6) and one Iockwasher (7).
(c) Position access cover (4) on switch box (5) and secure with 24 screws (1), 24 Iockwashers (2) and 24
flat washers (3).
Connector Replacement. (See figure 5-7.) A damaged or defective connector is replaced by replacing the
entire connector cable assembly.
Figure 5-7. Connector Replacement.
To avoid risk of injury or death by electrocution, do not
while either power unit is still connected to switch box.
remove switch box access cover