TM5-6115-640-14&P
(2)
Remove screw (6) attaching each indicator light wire terminal (7) to its respective threaded switch terminal (8).
Tag and disconnect power cable wire (10) and indicator light wire (9) from switch terminal.
(3)
Unscrew nut (11) and lockwasher (12) securing indicator light housing (13) to cover (4) and slide nut and
lockwasher off wires.
(4)
Pull out light and wire assembly through cover.
c.
Repair. The light and wire assembly is repaired by replacing defective lens, bulbs, housing, or soldering broken
wires. Soldering shall be done in accordance with TB SIG 22.
d.
Installation.
(1)
Feed wires through hole in cover (4) and fit light housing (13) into hole.
(2)
Slide lockwasher (12) and nut (11) over both indicator light wires (9) and tighten.
(3)
Position terminal (7) of each indicator light wire (9) against underside of switch terminal (8). Position terminal of
load cable wire (10) against terminal of indicator light wire. Insert screw (6) through wire terminals and tighten
into threaded switch terminal (8).
(4)
Position cover (4) on switch box (5) and secure with 16 flat washers (3), lockwashers (2), and screws (1).
Section XIII. POWER CABLE ASSEMBLY MAINTENANCE
4-24. POWER CABLE ASSEMBLY MAINTENANCE.
This task covers:
1. Test
3. Installation
2. Removal
Initial Setup:
1.
Tools - Multimeter AN/PSM-45 (6625-01-139-2512)
- General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Cable Assembly (94703); 13212E3571-4/-5,
13212E3570-3/-4
4-38
