TM5-6115-640-14&P
Section XII. LIGHT AND WIRE ASSEMBLY MAINTENANCE
4-23. LIGHT AND WIRE ASSEMBLY MAINTENANCE.
This task covers:
1. Test
3. Repair
2. Removal
4. Installation
Initial Setup:
1.
Tools - Multimeter AW/PSH-45 (6625-01-139-2512)
- General Mechanics Tool Kit (5180-00-177-7033)
- Soldering Gun GTTA-3 (3439-00-004-0915)
2.
Materials/Parts - Lens (72619); 181-0937-003
- Light (58224); NE2G
- Housing (72619); 181-8836-09-553
- Light and Wire Assembly (97403); 13212E3560
WARNING
Make sure generator sets are shut down before performing any maintenance on wiring. Failure
to follow this precaution may result in injury or death by electrocution.
a.
Test. Refer to paragraph 4-19a(3).
b.
Removal (See figure 4-10). There are two indicator light and wire assemblies on the switch box. This
procedure is typical for both. When attaching wires, refer to the schematic inside the switch box (figure 4-4).
(1)
Remove 16 screws (1, figure 4-10), lockwashers (2) and flat washers (3) securing cover (4) to switch box (5) and
take cover off switch box.
4-36
