TM 9-6115-730-24
0119
ASSEMBLY
1. If removed, install bearing (Figure 1, Item 22) in unit injector rocker arm (Figure 1, Item 13) so that oil hole
openings in bearing are centered over oil passages in rocker arm, and so that bearing does not extend
beyond either face of rocker arm.
2. If removed, install dowel (Figure 1, Item 21) in support (Figure 1, Item 18) so that it extends 0.178-0.216 in.
(4.5-5.5 mm) (Figure 2, Dimension D) from bottom of support.
3. If removed install plug (Figure 1, Item 20) in shaft (Figure 1, Item 17) to a depth of 0.39-0.59 in. (1.0-1.5 mm)
(Figure 2, Dimension E).
4. Install inlet valve rocker arm (Figure 1, Item 16), unit injector rocker arm (Figure 1, Item 13), exhaust valve
rocker arm (Figure 1, Item 8), spring pin (Figure 1, Item 19), and shaft (Figure 1, Item 17) in support (Figure 1,
Item 18). Install spring pin (Figure 1, Item 19) so that it extends 1.54-1.61 in. (39-41 mm) (Figure 2,
Dimension F) from the opposite side of the shaft (Figure 1, Item 17).
5. Install adjustment screw (Figure 1, Item 15) and nut (Figure 1, Item 14) on inlet valve rocker arm (Figure 1,
Item 16).
6. Install O-ring (Figure 1, Item 12), button (Figure 1, Item 11), adjustment screw (Figure 1, Item 10), and nut
(Figure 1, Item 9) on unit injector rocker arm (Figure 1, Item 13).
7. Install adjustment screw (Figure 1, Item 7) and nut (Figure 1, Item 6) on exhaust valve rocker arm (Figure 1,
Item 8).
8. Repeat steps 1 thru 7 for five remaining rocker arm assemblies.
END OF TASK
INSTALLATION
1. Lubricate top pad of two valve bridges (Figure 1, Item 5) with engine oil and install.
2. Install two valve pushrods (Figure 1, Item 4), injector pushrod (Figure 1, Item 3), rocker arm assembly (Figure
1, Item 2), and two bolts (Figure 1, Item 1).
3. Repeat steps 1 and 2 for remaining five rocker arm assemblies.
4. Perform valve lash check.
END OF TASK
0119-5
