TM 9-6115-730-24
0119
REMOVAL
NOTE
Place identification mark on each rocker arm to assure installation in the proper location.
1. Remove two bolts (Figure 1, Item 1) and rocker arm assembly (Figure 1, Item 2).
2. Remove injector pushrod (Figure 1, Item 3) and two valve pushrods (Figure 1, Item 4). Keep each pushrod
(Figure 1, Item 3) and (Figure 1, Item 4) with its rocker arm assembly (Figure 1, Item 2).
3. Remove two valve bridges (Figure 1, Item 5).
4. Repeat steps 2 thru 4 for remaining five rocker arm assemblies.
END OF TASK
DISASSEMBLY
1. Remove nut (Figure 1, Item 6) and adjustment screw (Figure 1, Item 7) from exhaust valve rocker arm (Figure
1, Item 8).
2. Remove nut (Figure 1, Item 9), adjustment screw (Figure 1, Item 10), button (Figure 1, Item 11), and O-ring
(Figure 1, Item 12) from unit injector rocker arm (Figure 1, Item 13).
3. Remove nut (Figure 1, Item 14) and adjustment screw (Figure 1, Item 15) from inlet valve rocker arm (Figure
1, Item 16).
4. Remove shaft (Figure 1, Item 17), from support (Figure 1, Item 18), and remove spring pin (Figure 1, Item 19),
exhaust valve rocker arm (Figure 1, Item 8), unit injector rocker arm (Figure 1, Item 13), and inlet valve rocker
arm (Figure 1, Item 16).
5. If necessary, remove plug (Figure 1, Item 20) from shaft (Figure 1, Item 17), and remove dowel (Figure 1,
Item 21) from support (Figure 1, Item 18).
6. If necessary, remove bearing (Figure 1, Item 22) from unit injector rocker arm (Figure 1, Item 13).
7. Repeat steps 1 thru 6 for remaining five rocker arm assemblies.
0119-2
