TM 9-6115-730-24
0075
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open right front doors.
3. Note routing of alternator belts (Figure 1, Item 1).
WARNING
Fan has sharp blades. Use caution and wear gloves when removing or installing belts. Failure to
comply can cause injury to personnel.
4. Turn nut (Figure 1, Item 2) counterclockwise (CCW) to relieve tension on alternator belts (Figure 1, Item 1) and
slip belts off alternator pulley (Figure 1, Item 3), fan pulley (Figure 1, Item 4), and crankshaft pulley (Figure 1,
Item 5).
5. Carefully thread alternator belts (Figure 1, Item 1) over fan blades and remove belts.
END OF TASK
INSTALLATION
WARNING
Fan has sharp blades. Use caution and wear gloves when removing or installing belts. Failure to
comply can cause injury to personnel.
1. Carefully thread alternator belts (Figure 1, Item 1) over fan blades.
2. Position alternator belts (Figure 1, Item 1) on crankshaft pulley (Figure 1, Item 5), fan pulley (Figure 1, Item 4)
and alternator pulley (Figure 1, Item 3).
3. Turn nut (Figure 1, Item 2) clockwise (CW) to increase belt tension.
4. Perform belt tension adjustment.
0075-2
