TM 9-6115-730-24
0045
DISASSEMBLY - Continued
NOTE
Cut tiedown straps as required.
5. Remove 13 jam nuts (Figure 1, Item 8), lockwashers (Figure 1, Item 9), and washers (Figure 1, Item 10), and
tag and disconnect wires from rear of reconnection terminal board assembly (Figure 1, Item 6).
6. Remove 13 jam nuts (Figure 1, Item 11), bus bar (Figure 1, Item 12), 13 studs (Figure 1, Item 13), 13 locknuts
(Figure 1, Item 14), and moveable terminal board (Figure 1, Item 15).
END OF TASK
ASSEMBLY
1. Install moveable terminal board (Figure 1, Item 15) on terminal board assembly (Figure 1, Item 6), and secure
with 13 locknuts (Figure 1, Item 14), 13 studs (Figure 1, Item 13), bus bar (Figure 1, Item 12), and 13 jam nuts
(Figure 1, Item 11).
2. Remove tags and connect wires to rear of reconnection terminal board assembly (Figure 1, Item 6), and
secure with 13 washers (Figure 1, Item 10), lockwashers (Figure 1, Item 9) and jam nuts (Figure 1, Item 8).
NOTE
Install tiedown straps as required.
3. Position reconnection terminal board assembly (Figure 1, Item 6) on its lower mounting and two standoffs
(Figure 1, Item 7), and secure with four standoffs (Figure 1, Item 5) and two screws (Figure 1, Item 4).
4. Install protective cover (Figure 1, Item 3) and secure with four washers (Figure 1, Item 2) and locknuts
(Figure 1, Item 1).
5. Close right rear doors.
6. If required, reprogram GSC and DVR parameters per WP 0083.
END OF TASK
END OF WORK PACKAGE
0045-3/4 blank
