TM 9-6115-729-24
0097
REMOVAL - Continued
WARNING
The generator weighs more than 1500 pounds (680 kg) and requires an assistant and a lifting
device (forklift, overhead lifting device) with sufficient capacity. Be careful and keep hands and
arms out of the way when lifting generator out of engine generator base. Failure to comply can
cause serious injury or death to personnel.
13. Attach suitable lifting device with at least 2000 lb (907 kg) capacity to lifting eye (Figure 1, Sheet 2, Item 22) on
generator (Figure 1, Sheet 2, Item 11) and take slack out of lifting device.
14. Remove two locknuts (Figure 1, Sheet 2, Item 23), two screws (Figure 1, Sheet 2, Item 24), four washers
(Figure 1, Sheet 2, Item 25), and four snubbing washers (Figure 1, Sheet 2, Item 26) from generator shock
mounts (Figure 1, Sheet 2, Item 27).
15. Carefully lift generator (Figure 1, Sheet 2, Item 11) out of engine generator base.
END OF TASK
INSTALLATION
WARNING
The generator weighs more than 1500 pounds (680 kg) and requires an assistant and a lifting
device (forklift, overhead lifting device) with sufficient capacity. Be careful and keep hands and
arms out of the way when lifting generator out of engine generator base. Failure to comply can
cause serious injury or death to personnel.
1. Install two top generator shock mounts (Figure 1, Sheet 2, Item 27), snubbing washers (Figure 1, Sheet 2, Item
26), and washers (Figure 1, Sheet 2, Item 25).
2. Using suitable lifting device with at least 2000 lb (907 kg) capacity, carefully lower generator (Figure 1, Sheet 2,
Item 11) onto engine generator base and align with engine (Figure 1, Sheet 2, Item 17).
3. Install two bottom generator shock mounts (Figure 1, Sheet 2, Item 27), snubbing washers (Figure 1, Sheet 2,
Item 26), with two screws (Figure 1, Sheet 2, Item 24) and two locknuts (Figure 1, Sheet 2, Item 23). Torque
screws to 216-264 lb-ft (293-357 Nm).
4. Turn two jackscrews (Figure 1, Sheet 2, Item 16) counterclockwise (CCW) to lower engine (Figure 1, Sheet 2,
Item 17) into proper alignment with generator (Figure 1, Sheet 2, Item 11). Tighten two nuts (Figure 1, Sheet 2,
Item 15).
5. Allow slack in lifting device and disconnect from lifting eye (Figure 1, Sheet 2, Item 22) on generator (Figure 1,
Sheet 2, Item 11).
6. Align holes and install 12 lockwashers (Figure 1, Sheet 2, Item 21) and screws (Figure 1, Sheet 2, Item 20).
Align holes and install eight lockwashers (Figure 1, Sheet 2, Item 19) and screws (Figure 1, Sheet 2, Item 18).
Torque screws (Figure 1, Sheet 2, Item 20) and (Figure 1, Sheet 2, Item 18) to 41-49 lb-ft (56-66 Nm).
7. Install air exhaust screen (Figure 1, Sheet 2, Item 14), two screws (Figure 1, Sheet 2, Item 13), and nuts
(Figure 1, Sheet 2, Item 12).
0097-5
