TM 9-6115-729-24
0092
INSTALLATION
NOTE
Three nuts can be accessed from under the bottom of the skid base and two nuts can be
accessed from right side of bracket.
1. Install vertical heater mounting bracket (Figure 1, Item 22) and secure with five screws (Figure 1, Item 29),
washers (Figure 1, Item 28), and locknuts (Figure 1, Item 27).
NOTE
Horizontal heater bracket attaches in one place to vertical bracket and two places to skid base.
2. Install horizontal heater bracket (Figure 1, Item 26), and secure with three screws (Figure 1, Item 25),
washers (Figure 1, Item 24), and locknuts (Figure 1, Item 23).
3. Install heater (Figure 1, Item 6) on vertical heater mounting bracket (Figure 1, Item 22) and secure with four
washers (Figure 1, Item 21), lockwashers (Figure 1, Item 20), and screws (Figure 1, Item 19).
4. Connect flexible exhaust tubing (Figure 1, Item 18) on heater (Figure 1, Item 6) and install hose clamp
(Figure 1, Item 17).
5. Install fuel metering pump (Figure 1, Item 5) and clamp (Figure 1, Item 16) on heater (Figure 1, Item 6) and
secure with washer (Figure 1, Item 15) and screw (Figure 1, Item 14).
6. Connect 90-degree elbow coolant hose (Figure 1, Item 13) to bottom of heater (Figure 1, Item 6) and install
hose clamp (Figure 1, Item 12).
7. Connect 90-degree elbow coolant hose (Figure 1, Item 11) to top of heater (Figure 1, Item 6) and install hose
clamp (Figure 1, Item 10).
8. Connect generator set wiring harness (Figure 1, Item 9) connectors P28 and P29 to heater (Figure 1, Item 6)
in two places.
9. Connect flexible braided hose (Figure 1, Item 8) to OUT side of fuel metering pump (Figure 1, Item 5) and
install hose clamp (Figure 1, Item 7).
10. Connect low-pressure hose (Figure 1, Item 4) to IN side of fuel metering pump (Figure 1, Item 5) and install
hose clamp (Figure 1, Item 3).
11. Open shutoff valves (Figure 1, Item 2) and (Figure 1, Item 1).
12. Close battery access doors and right front door.
END OF TASK
END OF WORK PACKAGE
0092-4
