TM 9-6115-729-24
0091
DISASSEMBLY
1. Remove two screws (Figure 1, Item 7), control box mounting bracket (Figure 1, Item 8), and control box
faceplate (Figure 1, Item 9) from control box frame (Figure 1, Item 10).
NOTE
Tag and disconnect wiring during component removal.
2. Remove collar (Figure 1, Item 11), jam nut and lockwashers (Figure 1, Item 12), and LED holder (Figure 1,
Item 13) from control box faceplate (Figure 1, Item 9).
3. Remove lens cap (Figure 1, Item 14), jam nut and lockwashers (Figure 1, Item 15), and press-test indicator
light (Figure 1, Item 16) from control box faceplate (Figure 1, Item 9).
4. Remove jam nut and lockwashers (Figure 1, Item 17) and circuit breaker (Figure 1, Item 18) from control box
faceplate (Figure 1, Item 9).
5. Remove jam nut and lockwashers (Figure 1, Item 19) and toggle switch (Figure 1, Item 20) from control box
faceplate (Figure 1, Item 9).
6. Remove two screws (Figure 1, Item 21) and control box cover (Figure 1, Item 22) from control box frame
(Figure 1, Item 10).
7. Remove eight nuts (Figure 1, Item 23), screws (Figure 1, Item 24), connector J26 (Figure 1, Item 1) and J27
(Figure 1, Item 2) from control box frame (Figure 1, Item 10).
8. Remove two nuts (Figure 1, Item 25), washers (Figure 1, Item 26), screws (Figure 1, Item 27), and relay
(Figure 1, Item 28) from control box frame (Figure 1, Item 10).
9. Remove two nuts (Figure 1, Item 29), screws (Figure 1, Item 30), and terminal block and rectifier assembly
(Figure 1, Item 31) from control box frame (Figure 1, Item 10).
END OF TASK
ASSEMBLY
NOTE
Connect wiring as tagged and remove tags during component installation.
1. Install terminal block and rectifier assembly (Figure 1, Item 31) on control box frame (Figure 1, Item 10) with
two screws (Figure 1, Item 30) and nuts (Figure 1, Item 29).
2. Install relay (Figure 1, Item 28) on control box frame (Figure 1, Item 10) with two screws (Figure 1, Item 27),
washers (Figure 1, Item 26) and nuts (Figure 1, Item 25).
3. Install connectors J27 and J26 (Figure 1, Item 2) and (Figure 1, Item 1) on control box frame (Figure 1, Item
9) with eight screws (Figure 1, Item 24) and nuts (Figure 1, Item 23).
0091-3
