TM 9-6115-729-24
UNIT (FIELD) LEVEL MAINTENANCE
TACTICAL QUIET GENERATOR 100 kW, 50/60 Hz MEP-807A/PU-807A
INSTALLATION OF GENERATOR SET ON TRAILER
INITIAL SETUP:
Tools and Special Tools
Personnel Required
Lifting Device, 7000 lb (3175 kg) Capacity
Two
Shop Equipment, Automotive Maintenance,
Common No. 1 (WP 0119, Item 2)
References
Tool Kit, General Mechanic's (WP 0119, Item 1)
TM 9-2330-376-14&P
TM 9-6115-729-24P
WARNING
The 100 kW TQG weighs approximately 6100 lb (2767 kg) and requires a lifting device (forklift,
overhead lifting device) with sufficient capacity. Failure to comply can cause serious injury or
death to personnel.
Be extremely careful when working near the 100 kW TQG as it is being positioned on the trailer.
Failure to comply can cause injury to personnel.
INSTALLATION
1. Park M1061/M1061A1 trailer (Figure 1, Item 1) on level hard surface. Lower support legs (TM 9-2330-376-
14&P). Level trailer and chock wheels.
2. Using lifting device with sufficient capacity (at least 7000 lb (3175 kg), maneuver TQG (Figure 1, Item 2), with
control panel end toward tongue of trailer.
3. Slowly lower TQG (Figure 1, Item 2) into position onto trailer (Figure 1, Item 1).
4.
Align with mounting holes.
5. Remove lifting device.
NOTE
All TQG-mounting screws are installed with nuts on top of bed of trailer, except at location A, at
right rear of trailer.
6. Install eight screws (Figure 1, Item 3), 16 washers (Figure 1, Item 4), and eight nuts (Figure 1, Item 5) on
trailer (Figure 1, Item 1). Torque to 125 lb-ft (69 Nm).
0086-1
