TM 9-6115-729-24
0071
REMOVAL - Continued
18. Remove four screws (Figure 1, Sheet 1, Item 35), lockwashers (Figure 1, Sheet 1, Item 36), washers (Figure 1,
Sheet 1, Item 37), four spacers (Figure 1, Sheet 1, Item 38), four lock nuts (Figure 1, Sheet 1, Item 39), and
two air cleaner mounting bands (Figure 1, Sheet 1, Item 34).
19. Remove straight barb connector (Figure 1, Sheet 1, Item 40) from engine crankcase filter adapter.
END OF TASK
INSTALLATION
1. Install straight barb connector (Figure 1, Sheet 1, Item 40) on engine crankcase filter adapter.
2. Install two air cleaner mounting bands (Figure 1, Sheet 1, Item 34), four lock nuts (Figure 1, Sheet 1, Item 39),
four spacers (Figure 1, Sheet 1, Item 38), washers (Figure 1, Sheet 1, Item 37), lockwashers (Figure 1,
Sheet 1, Item 36), and four screws (Figure 1, Sheet 1, Item 35).
3. Install air cleaner (Figure 1, Sheet 1, Item 2) into air cleaner mounting bands (Figure 1, Sheet 1, Item 34) and
tighten two nuts (Figure 1, Sheet 1, Item 33).
4. Install air cleaner cover (Figure 1, Sheet 1, Item 31) by fastening four clamps (Figure 1, Sheet 1, Item 32).
5. Install two screws (Figure 1, Sheet 2, Item 27), lockwashers (Figure 1, Sheet 2, Item 28), washers (Figure 1,
Sheet 2, Item 29), spacers (Figure 1, Sheet 2, Item 30) and crankcase ventilation filter bracket (Figure 1,
Sheet 2, Item 26).
6. Install crankcase ventilation filter (Figure 1, Sheet 2, Item 10) on bracket (Figure 1, Sheet 2, Item 26) and
secure with two washers (Figure 1, Sheet 2, Item 25), lockwashers (Figure 1, Sheet 2, Item 24), and screws
(Figure 1, Sheet 2, Item 23).
7. Install swivel fitting (Figure 1, Sheet 2, Item 18) on bottom of crankcase ventilation filter (Figure 1, Sheet 2,
Item 10). Install two fittings (Figure 1, Sheet 2, Item 22), one to IN port and one to OUT port, on crankcase
ventilation filter (Figure 1, Sheet 2, Item 10).
8. Install adapter (Figure 1, Sheet 2, Item 21) and check valve (Figure 1, Sheet 2, Item 20) on right hand rear
engine dipstick port.
9. Connect hose (Figure 1, Sheet 2, Item 17) to swivel fitting (Figure 1, Sheet 2, Item 18) on bottom of crankcase
ventilation filter (Figure 1, Sheet 2, Item 10) and to check valve (Figure 1, Sheet 2, Item 20) on right hand rear
engine dipstick port and install two clamps (Figure 1, Sheet 2, Item 16).
10. Connect hose (Figure 1, Sheet 1, Item 15) to IN port fitting on crankcase ventilation filter (Figure 1, Sheet 2,
Item 10) and to straight barb connector (Figure 1, Sheet 1, Item 35) on engine crankcase filter adapter.
11. Connect air vent hose (Figure 1, Sheet 1, Item 12) to engine turbo and install clamp (Figure 1, Sheet 1,
Item 13).
12. Connect restricted tap sleeve (Figure 1, Sheet 1, Item 6) to air vent hose (Figure 1, Sheet 1, Item 12) and
install clamp (Figure 1, Sheet 1, Item 11).
0071-5
