TM 9-6115-729-24
0046
INSTALLATION
NOTE
Install tiedown straps as required.
1. Install battery cable 2C40 (Figure 1, Item 18) and connect to load board terminal G (WP 0043).
2. Close load board door.
3. Connect battery cable 2C40 (Figure 1, Item 18) to engine starter motor SM (Figure 1, Item 17).
4. Close right rear doors.
5. Install battery cable 24A40 (Figure 1, Item 14) and connect to engine starter motor SM (Figure 1, Item 17).
6. Install battery cable 2A40 (Figure 1, Item 16) and connect to engine starter motor SM (Figure 1, Item 17).
7. Close right front doors.
8. Connect battery cable 2A40 (Figure 1, Item 16) to battery disconnect switch BDS (Figure 1, Item 4).
9. Install battery cable 24D40 (Figure 1, Item 13) and connect battery cable 24D40 and battery cable 24A40
(Figure 1, Item 14) to battery BT1 (right battery) positive terminal (Figure 1, Item 15).
10. Connect battery cable 24D40 (Figure 1, Item 13) to slave receptacle SR (Figure 1, Item 11).
11. Install battery cable 1C40 (Figure 1, Item 2) and connect to slave receptacle SR (Figure 1, Item 11).
12. Push slave receptacle (Figure 1, Item 8) into TQG and install retainer (Figure 1, Item 12), four washers
(Figure 1, Item 10), screws (Figure 1, Item 9), and nuts (Figure 1, Item 8).
13. Close left rear doors.
14. Install battery cable 12A40 (Figure 1, Item 5) and connect to battery BT2 (left battery) positive terminal (Figure
1, Item 7) and to battery BT1 (right battery) negative terminal (Figure 1, Item 6).
15. Install battery cable 1A40 (Figure 1, Item 1) and connect to battery disconnect switch BDS (Figure 1, Item 4).
16. Connect battery cable 1C40 (Figure 1, Item 2) and battery cable 1A40 (Figure 1, Item 1) to battery BT2 (left
battery) negative terminal (Figure 1, Item 3).
17. Close right and left battery access doors.
END OF TASK
END OF WORK PACKAGE
0046-5/6 blank
