TM 9-6115-729-24
0045
DISASSEMBLY - Continued
4. Remove two locknuts (Figure 1, Item 2) two washers (Figure 1, Item 3), two screws (Figure 1, Item 4), and
turn load terminal board (Figure 1, Item 1) partly over.
5. Remove five locknuts (Figure 1, Item 5) and washers (Figure 1, Item 6), and tag and disconnect wires from the
rear of load terminal board (Figure 1, Item 1).
6. Remove five jam nuts (Figure 1, Item 7) and load terminals (Figure 1, Item 8).
7. Remove four locknuts (Figure 1, Item 9), washers (Figure 1, Item 10), two studs (Figure 1, Item 12), bus bar
(Figure 1, Item 11), bus bar (Figure 1, Item 13), N to GND EMI filter (Figure 1, Item 14), and cable (Figure 1,
Item 15).
8. Remove eight nuts (Figure 1, Item 16), eight screws (Figure 1, Item 17), varistors N (Figure 1, Item 18),
(Figure 1, Item 19), (Figure 1, Item 20), and (Figure 1, Item 21), EMI filters L1 (Figure 1, Item 22), L2
(Figure 1, Item 23), and L3 (Figure 1, Item 24), and ground plane bar (Figure 1, Item 25).
END OF TASK
ASSEMBLY
1. Install ground plane bar (Figure 1, Item 25) , EMI filters L3 (Figure 1, Item 24) , L2 (Figure 1, Item 23) , L1
(Figure 1, Item 22) , varistors L3 (Figure 1, Item 21) , L2 (Figure 1, Item 20) , L1 (Figure 1, Item 19) , and N
(Figure 1, Item 18) , eight screws (Figure 1, Item 17) , and nuts (Figure 1, Item 16).
2. Install cable (Figure 1, Item 15), GND EMI filter (Figure 1, Item 14), bus bar (Figure 1, Item 13), two studs
(Figure 1, Item 12), bus bar (Figure 1, Item 11), four washers (Figure 1, Item 10), and locknuts (Figure 1,
Item 9).
3. Install five load terminals (Figure 1, Item 8) and jam nuts (Figure 1, Item 7).
NOTE
Cut tiedown straps as required.
4. Remove tags, connect wires to rear of load terminal board (Figure 1, Item 1), and install five washers (Figure
1, Item 6) and locknuts (Figure 1, Item 5).
5. Position load terminal board (Figure 1, Item 1) and install two screws (Figure 1, Item 4), two washers (Figure
1, Item 3), and two locknuts (Figure 1, Item 2).
6. Remove tags and connect cables to front of load terminal board (Figure 1, Item 1).
7. Close load board door.
END OF TASK
END OF WORK PACKAGE
0045-3/4 blank
