TM 9-6115-729-24
0046
REMOVAL - Continued
3. Open right and left battery access doors.
NOTE
Cut tiedown straps as required.
4. Disconnect battery cable 1A40 (Figure 1, Item 1) and battery cable 1C40 (Figure 1, Item 2) from battery BT2
(left battery) negative terminal.
5. Disconnect battery cable 1A40 (Figure 1, Item 1) from battery disconnect switch BDS (Figure 1, Item 4) and
remove battery cable 1A40 (Figure 1, Item 1).
6. Disconnect battery cable 12A40 (Figure 1, Item 5) from battery BT1 (right battery) negative terminal (Figure 1,
Item 6) and from BT2 (left battery) positive terminal (Figure 1, Item 7) and remove battery cable 12A40.
7. Open left front doors.
8. Remove four nuts (Figure 1, Item 8), screws (Figure 1, Item 9), washers (Figure 1, Item 10), push slave
receptacle (Figure 1, Item 11), and retainer (Figure 1, Item 12) out of TQG.
9. Disconnect battery cable 1C40 (Figure 1, Item 2) from slave receptacle SR (Figure 1, Item 11) and remove
battery cable 1C40.
10. Disconnect battery cable 24D40 (Figure 1, Item 13) from slave receptacle SR (Figure 1, Item 11). Disconnect
battery cable 24D40 and battery cable 24A40 (Figure 1, Item 14) from battery BT1 (right battery) positive
terminal (Figure 1, Item 15) and remove battery cable 24D40.
11. Disconnect battery cable 2A40 (Figure 1, Item 16) from battery disconnect switch BDS (Figure 1, Item 4).
12. Open right front doors.
13. Disconnect battery cable 2A40 (Figure 1, Item 16) from engine starter motor SM (Figure 1, Item 17) and
remove battery cable 2A40.
14. Disconnect battery cable 24A40 (Figure 1, Item 14) from engine starter motor SM (Figure 1, Item 17) and
remove battery cable 24A40.
15. Open right rear doors.
16. Disconnect battery cable 2C40 (Figure 1, Item 18) from engine starter motor SM (Figure 1, Item 17).
17. Open load board door.
18. Disconnect battery cable 2C40 (Figure 1, Item 18) from load board terminal G, (WP 0043) and remove battery
cable 2C40.
0046-2